Adjusting The Subwoofer Level; Using Subwoofer Boost; Adjusting The Speaker Level; Enjoying The Fm/Am Radio - Panasonic SC-PT960 Operating Instructions Manual

Adjusting the subwoofer level

You can adjust the amount of bass. The unit automatically selects the
most suitable setting according to the type of playback source.
SUB W 1
SUBWOOFER
^---------------------------------------------------}
LEVEL
-CH SELECT
≥ To check the current setting, press [SUBWOOFER LEVEL].
≥ The setting you make is retained, and recalled every time you play the
same type of source.

Using Subwoofer Boost

Main unit only
You can enhance the subwoofer effect with strong bass.
BST ON,------.BST OFF
SW BOOST indicator
The SW BOOST indicator lights when
SW
Subwoofer Boost is turned on.
BOOST

Adjusting the speaker level

You can adjust the surround sound levels.
Preparation
≥ Press [i, ` VOL] to adjust the volume to normal listening level.
≥ Select "TEST TONE" from "SPEAKER SETTINGS" in "AUDIO" menu
(➜ 23).
1
Enter test tone mode.
e.g.
Test tone will be output to each channel in the
following order.
LEFT, CENTER, RIGHT,
SURROUND RIGHT, SURROUND LEFT
2
Adjust the speaker level for each
speaker. (CENTER, SURROUND
RIGHT, SURROUND LEFT)
`6 dB to i6 dB
≥ To exit the screen, press [SETUP].
∫ To adjust speaker level during play
(Effective when playing 5.1-channel sound or when Dolby Pro
Logic II is on.)
1 Press and hold [—CH SELECT] to select the speaker.
While the speaker channel is displayed, press [—CH SELECT].
L #C #R #RS #LS #SW
^---------------------------------------------}
≥ You can adjust SW (Subwoofer) only if the disc includes a
subwoofer channel and "ÎPLII" is not lit.
2 Press [3] (increase) or [4] (decrease) to adjust the speaker
level for each speaker.
C, RS, LS, SW: `6 dB to i6 dB
(L, R: Only the balance is adjustable.)
To adjust the balance of the front speakers, while "L" or "R" is selected,
press [2, 1].
# #
SUB W 2 SUB W 3
AUDIO - SPEAKER SETTINGS - TEST TONE
SPEAKER TRIM LEVEL
LEFT − −
CENTER 0dB
RIGHT − −
SURROUND RIGHT 0dB
SURROUND LEFT 0dB
SET
RETURN
EXIT : SETUP

Enjoying the FM/AM radio

DVD
FM/AM
-
2ND SELECT
1
Numbered
4
buttons
7
DISC
- CD MODE
,
STOP
SETUP
MENU

Manual tuning

1
Select "FM" or "AM".
FM/AM
≥ Main unit:
2
Select the frequency.
≥ Main unit:
≥ To start automatic tuning, press and hold
∫ Presetting stations manually
Up to 30 stations can be set in each band, FM and AM.
1 While listening to the radio broadcast
Press [OK].
2 While the frequency is flashing on the display
Press the numbered buttons to select a channel.
≥ To select a 2-digit number
e.g. 12: [S10] ➜ [1] ➜ [2]
Alternatively, press [X, W],
and then press [OK].
Main unit:
1 While listening to the radio broadcast
Press [MEMORY] twice.
2 While a channel no. is flashing on the display
Press [X TUNE W], and then press [MEMORY].
A station previously stored is overwritten when another station is
stored in the same channel preset.
FM frequency step
Main unit only
The step is factory-set to 0.2-MHz, but you can change it to receive
broadcasts allocated in 0.1-MHz steps.
1 Press [SELECTOR] to select "FM".
2 Press and hold [SELECTOR].
After a few seconds the display changes to show the current minimum
frequency. Continue to hold the button down. The minimum frequency
changes and the step is changed.
To return to the original step, repeat steps 1 and 2.
[Note]
After changing the setting, previously preset frequencies will be cleared.
Preset them again.
VOL
FM/AM iPod
2 3
SELECT
5 6
8 9
VOL
0 10
SLOW / SEARCH
,
SKIP
PAUSE PLAY
ONE TOUCH PLAY
OK
OK
RETURN
SELECTOR MEMORY
TUNE
–TUNE MODE
Press [SELECTOR].
Press [-TUNE MODE] to select
"MANUAL" on the display, and then press
[X TUNE W] to select the frequency.
[6, 5] (main unit: [X TUNE W]) until
the frequency starts scrolling. Tuning
stops when a station is found.
29