Control Reference Guide; Main Unit; The Unit's Display - Panasonic DMR-EA38VK Operating Instructions Manual

Control Reference Guide

Main Unit

EJECT
POWER
IN 2 IN 2 S VIDEO S VIDEO
 Cassette eject button .....................................(
 Disc tray open/close button ............................(
 Stop button .........................................(
 Play/1.3 button ......................................(
 Input select button ..........................................(
 Recording mode button ..................................(
 Recording button ............................................(
 DVD/VHS POWER on/off button
(/I POWER) ................................................(
 Press to switch the unit from on to standby mode or vice
versa. In the standby mode, the unit is still consuming a small
amount of power.
 IN2 input terminals ........................................(

The Unit's Display

 Recording indicator
 Main display section
 Tape indicator
 Progressive indicator
This indicator lights up when you select "24p" in "Progressive/
24p" ( 51).
6
RQT9058
Remote Control Cassette
signal sensor compartment
VIDEO VIDEO L L /MONO AUDIO R /MONO AUDIO R
The unit's display
14, 15, 16)
OPEN/CLOSE
DRIVE SELECT
RESET
Opening
CH CH
the front panel
13)  DVD/VHS drive indicator ..........................(
 Lights when the DVD or VHS drive is selected.
13)
 Drive select button ...................................(
 Drive changes each time you press [DRIVE SELECT].
14, 15)
 Reset button ...................................................(
16)
 DV IN terminal (for a digital video
16)
camcorder) .....................................................(
16)
 SD card slot ....................................................(
 USB port ........................................................(
10)
 One touch copying operation button
 From VHS to DVD ......................................................
 From DVD to VHS ......................................................
26)
 Scheduled recording indicator (
On:
When a scheduled recording program is registered and a
recordable disc or tape is inserted.
Flashes:
The scheduled recording indicator fl ashes when the unit cannot
go to scheduled recording standby (e.g. there is no disc or tape,
etc). It does not fl ash if Quick Start is off.
 Disc indicator
This indicator lights up when a disc that is supported by this unit
is inserted.
Disc tray
INPUT SELECT INPUT SELECT REC MODE REC MODE
REC
COPYING COPYING
SD CARD
Pull down.
REC
COPYING COPYING
17)
14, 15)
14, 15)
74)
27)
13)
13)
( 18)
( 19)