Operating Peripheral Equipment Using The Remote Control; Programming The Remote Control Code - Panasonic TC-26LX20 Operating Instructions Manual

Operating peripheral equipment using the remote control

Programming the remote control code

You can operate other manufacturers' components using this TV's remote control.
Preparation:
•
Connect the plug of the external component to the wall outlet.
•
Make sure the component is turned off.
POWER
CH
VOL VOL
CH
MENU
RECALL PAGE
1 2
4 5
7 8
R-TUNE SLEEP/PROG
0
PLAY
REW
PAUSE STOP
TV/VCR VCR CH
T V
1
SAP
POWER
2
RETURN
EXIT
3
GUIDE
3
6
Notes:
• If the component does not operate with the remote control,
9
repeat the procedure using another code. (Some brands have
multiple codes).
• If an incorrect code is entered, or if the procedure takes longer
than 30 seconds, the programming will fail.
FF
REC
To find the code not listed in the index
After step 2 above,
OPEN/CLOSE
CH
O K
+
VOL VOL
CH
1 2 3
4 5 6
7 8 9
0
Press to select the code.
• The code starts from the current device.
• Press POWER button to test the operation.
• Repeat the steps until the component code is
found. It may take many attempts before the
correct code is found.
Press to store the code.
Press and hold POWER and
OK together, for at least 5
seconds.
•
The mode selection
buttons flashes, and then
release the POWER and
OK.
Select the type of the
component.
•
The selected button light
and all others go out.
Enter the 3-digit infrared code
(see pages 34-36).
•
Factory default setting :
Panasonic
•
Press POWER to test the
operation.
33