Mode Setting For Start Print Signal (Input) - Epson CW-C6000A Technical Reference Manual

Mode setting for start print signal (input)

[Format]
^S(CNI,S,c
[Parameter] c
Description
c = Mode setting
[Function]
Configure the mode settings for the start print signal.
Value for parameter c
0
1
3
[Initial value]
0
[Examples of command transmissions]
Set the start print signal to "Print labels when a Low signal is input for 20 msec or longer".
The ^JUS command must be used to save the settings to the non-volatile memory in the printer.
An example of the command transmission is shown below. It is sent via USB or Ethernet from the computer.
^XA
^S(CNI,S,1
^JUS
^XZ
38
0/1/3
Ignore the start print signal (pin 10).
(Normal print mode in which the printer receives and prints data, without using the start
print signal input to the external I/O.)
Set the start print signal (pin 10) to the following mode:
Print labels when a Low signal is input for 20 msec or longer.
Set the start print signal (pin 10) to the following mode:
Print labels as long as a Low signal is input.
Definition range
Description