How To Fix The Lens Cap To The Projector - LG BX503JD Owner's Manual

Information
Regarding the projector lamp control
WARNING
Don't turn off the projector at least in 5 minutes after activating it.
l
- The frequent On/Off changes may cause the lamp function to deteriorate.
Don't pull out the power cord while activating the projector and the cooling fan.
l
- It may cause the lamp life-span to shorten and get damaged.
The life-span of projector may considerably depend on the use environment and treatment conditions.
l
The projector uses the high pressure mercury lamp so that the serious caution is essential. The shock or abuse while using
l
may cause lamp to blow off with explosion.
When you continue to use the projector after an interval of lamp replacement, the lamp may be blown off with explosion.
l
The following treatment should be done, in case of lamp blow-off.
l
- Pull off the power cord immediately.
- Let some fresh air in immediately (Ventilation).
- Check the product condition at the nearer service center and replace it with new lamp, if necessary.
- Don't try to disassemble the product without the authorized technician.

How to fix the lens cap to the projector

How to fix the lens cap
1 Prepare the lens cap and the strap supplied as
accessories.
Fix the strap at the hole of the projector into the
hole of the lens cap, and then pass the lens cap
3
through the strap lasso.
41
2
Insert the non-knot end of the strap into the hole
at the bottom of the lens section of the projector.
They are completely assembled as shown at
4
the below figure.