Table of Contents
Advertisement
4. Refer to the inset drawing. Detach the Reed Switch
Wire (52) from the Resistance Control Wire (48).
Plug the Reed Switch Wire into the back of the
Console (43). Next, route the Resistance Control
Wire (48) on top of the Upright (6) so that it will fit
beneath the Console (43). Make sure that the
Resistance Control Wire is not kinked and that it
does not block the indicated hole.
Place the Console (43) on top of the Upright (6).
Attach the Console with six #8 x 1/2Ó Screws (64).
Press the Resistance Knob (63) firmly onto the
Resistance Control (48).
5. Slide a 3/4Ó Spacer (58) onto the left side of the
Upright (6). Make sure that the open side of the
Spacer is facing the Upright. Next, press a Plastic
Washer (55) into a Large Pivot Cover (54). Make
sure that the Plastic Washer is turned so it is flush
with the Large Pivot Cover. Slide the Plastic Washer
and the Large Pivot Cover onto the Upright.
Make sure that there are two Bushings (22) in the
Left Handlebar (5). Slide the Left Handlebar onto the
Upright (6).
Slide a Small Pivot Cover (56) and a 5/8Ó Washer
(59) onto the Upright (6). Using the included push
nut tool, tap a Push Nut (60) onto the Upright (see
the inset drawing). Press a Pivot Cap (57) into the
Small Pivot Cover.
Repeat this step to attach the Right Handlebar (not
shown).
6. Make sure that there are two 3/4Ó Bushings (18) in
the front end of the Right Outer Leg (2). Attach the
Right Handlebar (4) to the Right Outer Leg with a
5/16Ó x 1 3/4Ó Carriage Bolt (61) and a 5/16Ó Nylon
Jam Nut (62). Make sure that the head of the
Carriage Bolt is in the square hole in the Right
Handlebar.
Attach the Left Handlebar (5) to the Left Outer Leg
(3) in the same way.
7. Make sure that all parts of the elliptical crosstrainer are properly tightened. To protect the floor or carpet
from damage, place a mat under the elliptical crosstrainer.
4
43
Hole
52
48
64
5
5
56
59
60
57
6
7
43
6
6
6
58
55
54
Push Nut
22
Tool
5
3
61
18
63
48
64
60
6
4
62
2
Advertisement
Table of Contents
