Open/Close Slider; Security; Codes; Calling - Siemens AL21A Manual

Table of Contents

Advertisement

of AL21a, FCC, am (31.03.2006, 10:40)
ight page (11)

Open/close slider

Opening the slider
• Illumination on.
• Keypad unlocked.
• The call is accepted.
• Alarm sound off (appointment, alarm).
Closing the slider
• Back to standby mode.
• Illumination off.
• Keypad locked (if set).
• The call is ended.
• The call is rejected.
• Alarm sound off (appointment, alarm).

Security

m
¢
§Menu§
¢
Select function.
The phone and SIM card are protected
against misuse by several security codes.
Keep these confidential numbers in a safe
place where you can access them again if
required.

Codes

PIN control
You can stop the PIN prompt being
activated when the phone is switched on,
but you then risk unauthorised use of the
phone.
Press
§Change§
with
.
§OK§
Change PIN
You can change the PIN to any 4- to 8-dig-
it number you find easier to remember.
Change PIN2
(Display only if PIN2 is available).
Proceed as with
AL21a, FCC am, 31.03.2006
¢
Security
. Enter PIN and confirm
Change
PIN.
Open/close slider
Chg.phonecode
You define the phone code (4-8 digits)
when you call up a protected function for
the first time. It is then valid for all phone-
code protected functions.
Clear SIM card barring
If the PIN is entered incorrectly three
times, the SIM card is barred. Enter the
PUK (MASTER PIN), provided by your serv-
ice provider with the SIM card, according
to instructions. If the PUK (MASTER PIN)
has been lost, please contact your service
provider.
Preventing accidental activation
Even if PIN control is deactivated confir-
mation is required to switch on the
phone.
This prevents the phone from being
switched on accidentally, e. g. when car-
ried in a pocket or whilst you are on an
aircraft.
Press and hold the On/Off/End key
and confirm with
§OK§
switches on.

Calling

Dialling with number keys
The phone must be switched on (standby
mode) and the slider must be fully open.
Dial number (always with area code, if
necessary with international dialling
code). To dial international dialling code
0
press and hold
until a "+" is displayed.
Press
and select country.
§Country§
To dial press the Call key
Accept call
An incoming call will interrupt any other
use of the phone. Press
open slider fully.
Please make sure you have accepted the call
before holding the phone to your ear. This will
avoid damage to your hearing from loud ring
tones!
11
B
. The phone
A
.
A
or
or
§Answer§

Advertisement

Table of Contents
loading

Table of Contents