Related Manuals for NatComm Easy-Transfer
Summary of Contents for NatComm Easy-Transfer
- Page 1 Easy-Transfer Two Extension Transfer Device For Technical Assistance Ph: 07 5596 5128 (9AM to 5PM QLD Time) or email : info@natcomm.com.au...
- Page 2 DESCRIPTION Our EASY-TRANSFER Line Sharer is designed to connect to ANY TELEPHONE SOCKET and then allow TWO standard telephones that are connected direct to it, to operate as extensions of your ordinary single telephone line. You can then transfer a call, from one of the telephone extensions connected to EASY-TRANSFER, to the other telephone extension, by dialing *.
-
Page 3: Packing List
PACKING LIST Before commencing installation, please check that you have the following items: Description Quantity EASY-TRANSFER Line Sharer Power Supply Telephone Cable For technical assistance, please contact National Communications on (07) 55965128, 9AM to 5PM Monday - Friday (QLD TIME). -
Page 4: Installation Procedure
(Note – Only this phone will ring if power is lost or disconnected from Easy-Transfer). 4. CONNECT your OTHER Telephone or Telephone Device to the port of EASY-TRANSFER labelled EXT A, using the cable currently used with this device, or using one of our supplied cables. -
Page 5: Installation Diagram
INSTALLATION DIAGRAM Natcomm Page 5... -
Page 6: Operation
OPERATION Once your EASY-TRANSFER device has been installed as per our instructions, you will be able to transfer an incoming or outgoing call from any telephone connected to your line (including those telephones not connected direct to an EASY-TRANSFER), to either telephone connected to the EASY-TRANSFER. -
Page 7: User Options
(or make a call) can access the telephone conversation. The Other phone will not be able to hear or participate in a conversation. Note - Telephones NOT connected to EASY-TRANSFER cannot be blocked from the line. PARTY MODE - When EASY-TRANSFER are set in PARTY MODE, Both telephones connected to the line can participate in a telephone conversation at the same time. -
Page 8: Dip Switch Settings
If set to ON, both telephones attached to this unit will RING with an incoming telephone call. If set to OFF, only the telephone connected to port B or this unit will RING with an incoming telephone call. SWITCHES 3 & 4 - Are not used Page 8 Natcomm... - Page 9 This product has been tested by an authorized independent laboratory to comply with all Telephone Line and Electromagnetic Compliance requirements for Australia, USA and Canada. The Power adaptor supplied with this product complies with Australian, UL (USA) and cUL (Canada) specifications. Natcomm Page 9...
-
Page 10: Specifications
Idle - 0.5 W; Call – 0.75W Line IN Connector RJ 11 6 pin (2 center) Line OUT Connector RJ 11 6 pin (2 center) Power Connector 2.5mm barrel connector ACMA, FCC & IC COMPLIANT Supplier Number NC Ringer Equivalence Number 0.1 REN Page 10 Natcomm... - Page 11 NOTES Natcomm Page 11...
-
Page 12: Warranty
Damage caused to this device or attached equipment by lightning strikes or over voltage surge is not covered under this warranty. THE CASE IS SEALED AT THE FACTORY. OPENING THE CASE WILL VOID THE WARRANTY Page 12 Natcomm...