Related Manuals for NatComm TONE ALERT
Summary of Contents for NatComm TONE ALERT
- Page 1 TONE ALERT ACCESSORY For Technical Assistance Please Ph: 07 5596 5128 Page 1 Natcomm...
- Page 2 Mylar Speaker to produce an Alert Tone or Alarm Tone, rather than the annoying very high frequency of inexpensive ‘Piezo Alarms’. Tone Alert is NOT a Loud Ringer itself. If that solution is required please contact Natcomm to request a Siren Alert.
- Page 3 INSTALLATION WITH NATCOMM DEVICE Page 3 Natcomm...
-
Page 4: Installation
Connect your Natcomm switching device to the ‘Relay Input’ socket of Tone Alert. Connect the 3.5mm ‘Audio Out’ port of Tone Alert to an external speaker or amplifier – if required, for increased volume Connect the power supply of the Natcomm switching device to the switching device and turn power on. - Page 5 INSTALLATION WITH SEPARATE SWITCH Page 5 Natcomm...
- Page 6 Connect your Dry Contact switch to the centre two pins of the Tone Alert ‘Relay Input’ socket Connect the 3.5mm ‘Audio Out’ port of Tone Alert to an external speaker or amplifier – if required, for increased volume Connect the supplied 12V power supply (or your own 12V 500mA minimum) power supply to the 12V power socket of Tone Alert and turn power on.
-
Page 7: Dip Switch
DIP SWITCH A Micro Dip Switch is located on the underneath side of Tone Alert. It is a 4 position Dip Switch which is provided for the purposes of: 1. Changing the Frequency of the Alert Tone 2. Changing the ON to OFF Cadence of the Alert Tone... -
Page 8: Specifications
Damage caused to this device or attached equipment, by lightning strikes or over voltage surge is not covered under this warranty. CASE SEALED AT FACTORY OPENING THE CASE VOIDS THE WARRANTY Page 8 Natcomm...