Canon EOS 620-650 User Manual page 41

Three selectable modes:
1. ONE SHOT: AF operation ends and focus is locked once ranging is completed. Shutter does not release until
ranging is completed.
2. SERVO: Focus continuously adjusts to follow the subject movement. Shutter can be released at any time
regardless of ranging completion.
3. Manual: By rotating the manual focusing ring after focus mode switch is set to "M".
AF Working Range: EV 1 - 18 at ISO 100
AF Auxiliary Light:
The ultra-bright red LED (peak sensitivity: 700 nm) is automatically projected with specified Canon Speedlites.
Shutter:
Vertical-travel focal plane shutter with soft-touch electromagnetic release. All speeds electronically controlled.
Shutter Speed:
EOS650--1/2000--30 sees and bulb. X-sync is 1/125 sec. Can be set in 1/2-step increments.
EOS 620--1/4000--30 sees and bulb. X-sync is 1/250 sec. Can be set in 1/2-step increments.
Self-timer:
Electronically controlled with a delay of approx. 10 sees indicated by blinking LED operation confirmation lamp.
Film Loading:
After film positioning and back cover closure, the film automatically advances to the first usable frame and then
stops (approx. 1.5 sees)
Film Wind:
Automatic using the built-in miniature motor. Confirmation by the film transport bar marks in the display panel.
Film Winding Mode:
Two selectable modes; S (single exposure) and C (continuous exposure at the maximum speed of approx. three
frames per second).
Film Rewind:
Automatic using the built-in miniature motor. Starts when the film end is reached and then stops (with 24-exp.
film, approx. 10 sees with the EOS 650 and approx. 7 sees with the EOS 620). Mid-roll rewind performed by
pressing the film rewind button.
Flash Contact: Coupled directly to the camera by X-sync contact on the accessory shoe.
Automatic Flash (using the Speedlite 420el 300EZ with the camera set to "P"):
A-TTL flash auto--Using the camera's A-TTL program and the flash's near-infrared preflash, the correct aperture
value is automatically set. Xsync speed is also automatically set between 1/60 and 1/125 sec with the EOS 650
and between 1/60 and 1/250 sec with the EOS 620 upon flash charge completion. TTL control system which
meters the light reflected from the film surface. Automatic fill-in flash is possible.
Grip: Interchangeable.
The GR30 (without remote control terminal) is standard with the EOS 650.
The GR20 (with remote control terminal) is standard with the EOS 620.
The large-size, Grip GR10 is available optionally.
Depth of-Field Check:
By pressing the depth-of-field check button.
LCD Display Panel:
Displays only the information required at the time e.g. shooting mode, film winding mode, AF mode shutter
speed, aperture value, film speed, or battery check. Timer function for eight sees is provided; the display is held
on for eight sees after the switch i.e., shutter button is pressed. The EOS 620's display panel can be illuminated
by electrolum-nescence. Power Source: One, six-volt lithium battery pack (2CR5). Battery is replaced by
removing grip.
4www.butkus.org