Cooling / Fan Only Operation; Remote Control; Automatic Operation - Toshiba RAS-H10L4KCVG-V Owner's Manual

INDOOR UNIT DISPLAY
1
1 Timer (White)
2 Operation (White)
1 2
Display brightness can be adjusted, follow procedure on !.
●
PREPARATION BEFORE USE
2
Preparing Filters
1. Open the air inlet grille and remove the air filters.
2. Attach the filters. (see detail in the installation manual).
Loading Batteries (when use wireless operation.)
1. Remove the slide cover.
2. Insert 2 new batteries (AAA type) following
the (+) and (–) positions.
Remote Control Reset
1. Remove the batteries.
2. Press .
3. Insert the batteries.
AIR FLOW DIRECTION
3
Press : Move the louver in
1
the desired vertical direction.
Press : Swing the air
2
automatically and press again to stop.
3 For horizontal direction, adjust
manually.
Note:
Do not move the louver manually by others.
●
The louver may automation positioning by some operation mode.
●

REMOTE CONTROL

4
1 Infrared signal emitter
2 Start/Stop button ( )
3 Mode select button ( )
4 Temperature button ( )
5 Fan speed button ( )
6 Swing louver button ( )
7 Set louver button ( )
8 Off timer button ( )
9 High power button ( )
0 ECO button ( )
! Clear button ( )
@ Check button ( )

AUTOMATIC OPERATION

5
To automatically select cooling or fan only operation
1. Press : Select Auto A.
2. Press : Set the desired temperature. Min: 17°C, Max: 30°C
3. Press : Select AUTO, LOW , LOW+
MED+ , HIGH , or QUIET
1144180203_EN,VT.indd 4
1
3 4
2
6
7
5
9
0
8
!
@
, MED ,
.
COOLING / FAN ONLY
6
OPERATION
1. Press : Select Cool , or Fan only
2. Press : Set the desired temperature. Min: 17°C, Max: 30°C
Fan Only : No temperature indication
3. Press : Select AUTO, LOW , LOW+
MED+ , HIGH , or QUIET
DRY OPERATION
7
For dehumidification, a moderate cooling performance is controlled automatically.
1. Press : Select Dry .
2. Press : Set the desired temperature. Min: 17°C, Max: 30°C
Note: DRY mode fan speed is set to Auto only.
HI POWER OPERATION
8
To automatically control room temperature and airflow for faster cooling operation
(Except in DRY and FAN ONLY mode)
Press : Start and stop the operation.
Note: Hi-POWER operation symbol will appear on remote control display.
ECO OPERATION
9
To automatically control room temperature to save energy (except in DRY and
FAN ONLY mode)
Press : Start and stop the operation.
Note: Cooling operation; the set temperature will increase automatically 1
degree/hour for 2 hours (maximum 2 degrees increase). For heating
operation the set temperature will decrease.
TIMER OPERATION
10
Set the timer when the air conditioner is operating.
Setting the OFF timer
1 Press for enter OFF timer setting.
2
Press for select desired OFF timer. (0.5 - 12 hrs)
3 Press for set OFF timer.
4 Press again for cancel OFF timer.
Note: TIMER OPERATION symbol will appear on remote control display.
.
, MED ,
.
6/10/2564 18:30:49