Table of Contents
Advertisement
values around 0° C or drop below,
remove the remaining water from the
inlet hose and the drain pump.
1. Disconnect the mains plug from the
mains socket.
2. Close the water tap.
3. Put the two ends of the inlet hose in
a container and let the water flow out
of the hose.
4. Empty the drain pump. Refer to the
emergency drain procedure.
14. TROUBLESHOOTING
WARNING!
Refer to Safety chapters.
14.1 Introduction
The appliance does not start or it stops
during operation.
First try to find a solution to the problem
(refer to the "Possible failures" table). If
the problem persists, contact the
Authorised Service Centre.
In case of major problems, the acoustic
signals operate, the display shows an
alarm code and the Start/Pauze button
may flash continuously:
•
- The appliance does not fill with
water properly. After the proper
check, start the appliance again by
pressing Start/Pauze button. If the
error persist the alarm code will
appear again.
•
- The appliance does not drain
the water.
•
- The appliance door is open or
not closed correctly. Please check the
door!
If the appliance is
overloaded, remove
some items from the
drum and/or keep
pressed the door while
touching the Start/Pauze
button until the indicator
the picture below).
stops flashing (see
5. When the drain pump is empty,
install the inlet hose again.
WARNING!
Make sure that the
temperature is higher than 0
°C before you use the
appliance again.
The manufacturer is not
responsible for damages
caused by low temperatures.
•
- The mains supply is unstable.
Wait until the mains supply is stable.
•
- No communication between
electronic elements of the appliance.
Switch the appliance off and switch it
on again. If the alarm code appears
again, contact the Authorised Service
Centre.
•
- The anti-flood device is on.
Disconnect the appliance and close
the water tap. Contact the Authorised
Service Centre.
WARNING!
Deactivate the appliance
before carrying out any
check.
ENGLISH
29
Advertisement
Table of Contents
