Table of Contents
Advertisement
28
www.aeg.com
12. Close the pump cover.
13.8 Cleaning the inlet hose
and the valve filter
It is recommended to clean both the
filters of the inlet hose and valve
occasionally to remove any deposit,
collected over the time:
1. Remove the inlet hose from the tap
and clean the filter.
1
2
2. Remove the inlet hose from the
appliance by loosening the ring nut.
2
1
2
1
1
3
3. Clean the valve filter on the back of
the appliance with a toothbrush.
4. When you reconnect the hose to the
back of the appliance, turn it left or
right (not in vertical position)
depending on the position of your
water tap.
20°
13.9 Emergency drain
If the appliance cannot drain the water,
carry out the same procedure, described
in 'Cleaning the drain pump' paragraph.
If necessary, clean the pump.
13.10 Frost precautions
If the appliance is installed in an area
where the temperature can reach the
45°
Advertisement
Table of Contents
