Panasonic CF-AX3 Series Operating Instructions Manual page 34

Installing Software
8 At the License Agreement screen, click [Yes, I agree to the provisions
above and wish to continue!] and click [Next].
9 Click [Next].
If the option is displayed, select the setting and click [Next].
l [Reinstall Windows to the System Disk to factory default.]
Select this option when you want to install Windows to the factory default. After instal-
lation, you can create a new partition. For how to create a new partition, refer to "To
change the partition structure" (è page 22).
l [Reinstall to the OS related partitions.]
Select this option when the hard disk has already been divided into several partitions.
For how to create a new partition, refer to "To change the partition structure" (è page 22).
You can keep the partition structure.
*1
This does not appear if Windows cannot be installed to the recovery partition and the area us-
able by Windows.
10
11
<For localized OS model>
Select OS (32bit or 64bit) and click [OK].
<For MUI OS model>
Select language and system type (32bit or 64bit) and click [OK].
At the confirmation message, click [OK].
To cancel the recovery procedure, click [CANCEL], and click the
at the top right corner of the screen.
12 At the confirmation message, click [YES].
Installation starts according to the instructions on the screen. (It will take approximately 20
minutes.)
l Do not interrupt installation, for example by turning off the computer or performing other
operation.
„ Otherwise installation may become unavailable as Windows may not start up or the
data may be corrupted.
13 When Ending process screen is displayed, click [OK] to turn off the
computer.
14 Turn on the computer.
l If the password is requested, enter the Supervisor Password.
15 Perform the "First-time Operation", starting from step 6, "Setup Win-
dows" (è page 20).
NOTE
l
correctly.
16 Start the Setup Utility and change the settings as necessary.
17 Perform Windows Update.
18
34
At the confirmation message, click [YES].
The date and time, and the time zone may not be correct. Be sure to set them
<Only for model with TPM> Clear TPM (è page 33).
*1
mark that appears