DeWalt D25580K Manual page 8

Residual Risks
In spite of the application of the relevant safety
regulations and the implementation of safety
devices, certain residual risks cannot be avoided.
These are:
Impairment of hearing.
–
Risk of dust inhalation.
–
Risk of personal injury due to prolonged use.
–
– Risk of burns due to accessories becoming
hot during operation.
Markings on Tool
The following pictograms are shown on the tool:
Read instruction manual
before use.
Wear ear protection.
Wear eye protection.
DATE CODE POSITION
The Date Code, which also includesthe year of
manufacture, is printed into the housing.
Example:
2013 XX XX
Year of Manufacture
Package Contents
The package contains:
1 Heavy-duty demolition hammer
1 Side handle
1 Pointed chisel(for -B1,-XD)
1 Kitbox
1 Instruction manual
1 Exploded drawing
1 Warranty card
•
Check for damage to the tool, parts or
accessories which may have occurred during
transport.
•
Take the time to thoroughly read and
understand this manual prior to operation.
Description (fig. 1)
WARNING: Never modify the power tool
or any part of it. Damage or personal
injury could result.
a. Side Handle
b. Switch
c. Barrel cover
d. Tool sleeve
e. Dust cap
INTENDED USE
Your demolition hammer has been designed for
professional light or medium chipping, chiselling
and demolition applications in concrete, brick and
masonry.
DO NOT use under wet conditions or in presence
of flammable liquids or gases.
These demolition hammer are professional power
tools.
DO NOT let children come into contact with the
tool. Supervision is required when inexperienced
operators use this tool.
Electrical Safety
The electric motor has been designed for one
voltage only. Always check that the power supply
corresponds to the voltage on the rating plate.
Your D WALT tool is double insulated in
E
accordance with EN 60745; therefore no
earth wire is required.
If the supply cord is damaged, it must be replaced
by a specially prepared cord available through the
D WALT service organization.
E
Using an Extension Cable
An extension cord should not be used unless
absolutely necessary. Use an approved extension
cable suitable for the power input of your tool (see
technical data). The minimum conductor size is 1
mm 2 ; the maximum length is 30 m.
When using a cable reel, always unwind the cable
completely.
ASSEMBLY AND ADJUSTMENTS
WARNING: To reduce the risk of
injury, turn unit off and disconnect
machine from power source before
installing and removing accessories,
before adjusting or changing set-ups or
when making repairs. Be sure the trigger
switch is in the OFF position. An
accidental start-up can cause injury.
E NG LI SH
6