Table of Contents
Advertisement
L i f e B o o k P S e r i e s N o t e b o o k B I O S
SECURITY MENU – SETTING THE SECURITY FEATURES
The Security menu allows you to set up the data security
features of your notebook to fit your operating needs and
to view the current data security configuration. Follow
the instructions for Navigating Through the Setup Utility
to make any changes.
The following tables show the names of the menu fields
for the Security menu and its submenus, the options for
each field, the default settings and a description of the
field's function and any special information needed to
help understand the field's use. The default condition is
no passwords required and no write protection.
P O I N T
If you set a password, write it down and keep it in a
safe place. If you forget the password you will have to
contact your support representative to regain access to
your secured functions and data.
Main
Supervisor Password Is:
User Password Is:
Set Supervisor Password
Set User Password
Minimum User Password Length
Password on Boot:
Password on Resume:
Boot from Removable Media:
Floppy Disk Access:
Hard Disk Security
Owner Information
Hard Disk Boot Sector:
F1
Help
ESC
Exit
16
PhoenixBIOS Setup Utility
Advanced
Security
Select Item
-/Space
Select Menu
Enter
Figure 12. Security Menu
P O I N T S
• If you make an error when re-entering the password
a [Warning] will be displayed on the screen. To try
again, press the Enter key and then retype the pass-
word. Press the Esc key to abort the password setting
process.
• Entering a password incorrectly three times in a row
will cause the keyboard and mouse to be locked out
and the warning [System Disabled] to be displayed. If
this happens, restart the computer by turning off and
on the power with the power switch and use the
correct password on reboot.
• If the Password on Resume is Enabled and the Pass-
word on Boot is Disabled you will not have to type
your password upon resuming the system from the
Suspend or Save-to-Disk modes. Power Management
Security will work only if Password on Boot is
enabled.
Power
Boot
Info
Clear
Clear
Press <Enter> key to
set Supervisor password
[Enter]
to enable any password
[Enter]
features.
[0]
Then password entry is
[Disabled]
required to enter BIOS
[Disabled]
Setup.
[All]
[All]
[Normal]
Change Values
Select Sub-Menu
Exit
Item Specific Help
F9
Setup Defaults
F10
Save and Exit
Advertisement
Table of Contents
