Memory Problems; Modem Problems; Parallel, Serial And Usb Device Problems; Pc Card Problems - Fujitsu Lifebook N6010 User Manual

L i f e B o o k N S e r i e s U s e r ' s G u i d e
Problem

Memory Problems

Your Power On screen, or
Main menu of the BIOS
setup utility information,
does not show the correct
amount of installed
memory.

Modem Problems

Messages about modem
operation.
USB Device Problems
You have installed a USB
device, but your LifeBook
notebook does not recog-
nize the device, or the
device does not seem to
work properly.

PC Card Problems

A card inserted in the PC
Card slot does not work or
is locking up the system.
56
Possible Cause
Your memory upgrade module
is not properly installed.
You have a memory failure.
Messages about modem
operation are generated by
whichever modem application
is in use.
The device is not properly
installed.
The device may have been
installed while an application
was running, so your notebook
is not aware of its installation.
Your software may not have
correct software driver active.
You may have the wrong I/O
address selected for your
device.
Your device and another device
are assigned the same I/O
address.
The card is not properly
installed.
Your software may not have
the correct driver active.
The card may have been
installed while an application
was running, so your notebook
is not aware of its installation.
You may have the wrong
I/O address selected for your
PC Card device.
Your PC Card device and
another device are assigned the
same I/O address.
Possible Solutions
Remove and reinstall your memory upgrade
module. (See Memory Upgrade Module on page 45
for more information)
Check for Power On Self Test (POST) messages.
(See Power On Self Test Messages on page 61 for more
information)
See your application software documentation for
additional information.
Remove and reinstall the device. (See Device Ports on
page 47 for more information)
Close the application and restart your LifeBook
notebook.
See your software documentation and activate the
correct driver.
See your device documentation and software docu-
mentation to determine the required I/O address.
Change the settings in the BIOS setup utility. (See
BIOS Setup Utility on page 25 for more information)
Check all I/O addresses located within the BIOS
setup utility and any other installed hardware or
software to make sure there are no duplications.
Remove and reinstall the card. (See PC Card Slot on
page 44 for more information)
See your software documentation and activate the
correct driver.
Close the application and restart your LifeBook
notebook.
See your PC Card documentation to determine
the required I/O address. Change the settings in
the BIOS. (See BIOS Setup Utility on page 25 for
more information)
Check all I/O addresses located within the BIOS
setup utility and any other installed hardware or
software to make sure there are no duplications.