Headphone/Optical Digital Audio Out Jack; External Monitor Port - Fujitsu Lifebook N6010 User Manual

■ There are several types of cables for
connecting a digital electronic device
(e.g., MD player) to the digital audio-
out connector, depending on the
connector type. The connector on your
computer is a Optical Mini Plug (3.5mm
diameter mini plug)
The frequency of the digital sound
■
output from the SPDIF output
connector is selectable as 48.0 kHz or
44.1 kHz. If a sampling rate convertor is
not installed in your digital electronic
device (e.g., MD player), recording is
not possible. See the device user
manual for more details.
The sound recorded through
■
connecting a digital electronic device
(e.g., MD player) to the SPDIF output
connector cannot be used as digital
output. All output data from the SPDIF
output connector has copyright protec-
tion information included.
HEADPHONE/OPTICAL DIGITAL
AUDIO OUT JACK
The headphone/optical digital audio out jack allows you
to connect headphones or powered external speakers, or
to download digital audio to MiniDisc recorders or
connect to your sound system to play audio files. Your
device must be equipped with a 1/8" (3.5 mm) stereo
mini-plug. In order to connect headphones or speakers
follow these easy steps: (Figure 4-19)
1. Align the connector with the port opening.
2. Push the connector into the port until it is seated.
If you plug headphones into the
headphone jack, you will disable the built-
in stereo speakers.
The optical digital audio out function uses SPDIF (Sony
Philips Digital Interface) format. Please use the
following setting when using the digital audio-out
connector.
1. Click on Start, Settings and then click on
Control Panel.
2. Select Volume Control.
3. Click Options -> Advanced Control -> Advanced,
and click on Enable SPDIF.
U s e r - I n s t a l l a b l e F e a t u r e s
Figure 4-19 Headphone/Optical Digital Audio Out Jack

EXTERNAL MONITOR PORT

The external monitor port allows you to connect an
external monitor. In order to connect an external
monitor follow these easy steps:
1. Align the connector with the port opening.
2. Push the connector into the port until it is seated.
3. Tighten the two hold-down screws, located on
each end of the connector.
Pressing the [Fn] + [F10] keys allows you
to change your selection of where to send
your display video. Each time you press the
key combination, you will
step to the next choice, starting with the
built-in display panel only, moving to the
external monitor only, finally moving to
both the built-in display panel and an
external monitor.
Figure 4-20 External Monitor Connection
49