Replacing The Lamp 4 8; Lamp Replacement Procedure - JVC DLA-NP5 Instructions Manual

Replacing the Lamp 4 8

The lamp is a consumable item. If the image appears dark or the lamp goes out, replace the lamp unit.
When the lamp replacement time approaches, the user is notified with a message displayed on the screen and by
0
the indicator. (P. 114)

Lamp Replacement Procedure

CAUTION
Do not insert your hands into the lamp
0
compartment. This could cause significant
deterioration in the performance of the
equipment, or lead to injury and electric shock.
Do not replace the lamp immediately after the unit
0
has been used. Allow a cooling period of at least
one hour before replacement. The temperature of
the lamp is still high, and may cause burn injuries.
Do not subject the lamp unit to shock. Doing so
0
may cause lamp blowout.
Do not use a flammable air duster to clean the
0
internal parts of the unit. Doing so may cause fire.
Use only genuine replacement parts for the lamp
0
unit. Also, never attempt to reuse an old lamp unit.
Doing so may shorten the lamp life and cause a
malfunction.
Do not touch the surface of a new lamp. Doing so
0
may shorten the lamp life and cause lamp
blowout.
When replacing the lamp, be careful not to injure
0
yourself as the lamp may be broken.
When replacing the lamp of a projector
0
suspended from the ceiling, work at height is
required. This is a dangerous operation. Please
consult our service center.
Remove the power plug from the
1
outlet
Remove the lamp cover
2
Remove the screw with a t screwdriver
0
Loosen the screws of the lamp unit
3
Loosen the screws with a t screwdriver.
0
Pull out the lamp unit
4
Install the new lamp unit
5
91