Checking The Memory Capacity; Removing A Memory Module - Fujitsu Lifebook A6220 User Manual

Removing a Memory Module

1
Perform steps 1 through 4 of Installing a
Memory Upgrade Module.
2
Pull the clips sideways away from each
side of the memory upgrade module at the
same time.
3
While holding the clips out, remove the
module from the slot by lifting it up and
pulling it away from your notebook.
4
Store the memory upgrade module in a
static guarded sleeve.
5
Replace the cover and reinstall the screws.

Checking the Memory Capacity

Once you have changed the system memory capacity by replacing the installed module with a larger one,
be sure to check that your notebook has recognized the change.
Check the memory capacity by clicking [Start] > Control Panel > System and Maintenance > System.
The amount of memory is displayed next to "Memory - RAM:"
There may be a variation between the actual memory size and what is displayed. This is possible if your
system is configured with a graphics card that dynamically allocates system memory to accelerate
graphics performance.
I
F THE TOTAL MEMORY DISPLAYED IS INCORRECT
PROPERLY INSTALLED
CORRECTLY RECOGNIZED
Memory Clip
. (I
F THE MODULE IS PROPERLY INSTALLED AND THE CAPACITY IS STILL NOT
, T
SEE ROUBLESHOOTING ON PAGE
83 - Memory Upgrade Module
Figure 36. Removing memory module
,
CHECK THAT YOUR MEMORY UPGRADE MODULE IS
89.