Fujitsu Siemens Computers CELSIUS Mobile H230 Operating Manual page 69

4
► Make sure that the hoop (a) is in the position illustrated.
► Position the notebook so that the rear right-hand corner lies on the Port Replicator, as shown in
the illustration (1).
► Press down on the notebook's rear corners so that it may lock into position.
► Connect the mains adapter cable to the DC jack (DC IN) of the Port Replicator (2).
► Connect the power cable to the mains adapter (3).
► Plug the power cable into the mains socket (4).
If the notebook is connected to a Port Replicator, the operating system creates an
i
hardware profile for the "Docked" mode. In this profile, for example, the setting is saved as
to which monitor was last used for output. This profile will be loaded, as soon as the
notebook is connected to a Port Replicator of the same type.
A26391-K169-Z121-1-7619, edition 1
2
3
Using your notebook
1
a
59