Removing and installing components during servicing
Installing the hard disk
The hard drive frame is fitted with oblong slots, not normal screw holes. Depending to the
i
type of hard drive, the screws may have to be inserted into the slots either clockwise or
anti-clockwise.
The hard drive frame must be attached to the hard drive with 2 screws on either side.
►
Slide the hard disk (1) into the hard disk carrier.
►
Fasten the hard disk carrier with the screws (2).
Insert the hard disk at a slight angle into the hard disk tray in the direction indicated by the arrow (1).
►
Grasp the hard disk by the pulling aid and slide the hard disk in the direction of the arrow (2) to
plug the hard disk.
►
Fasten the screws (3).
58
2
2
1
3
3
1
2
2
2
3
10600690568, edition 1