Table of Contents
Advertisement
Chapter 3
¾ To enable or disable the extended network:
1. Go to
Settings
>
Wireless
2. Extended networks are enabled by default. If you want to disable the wireless
function of a certain band, just clear the
settings of this band will be invalid.
¾ To change the wireless network name (SSID):
1. Go to
Settings
>
Wireless
2. Create a new SSID in
sensitive.
Note:
If you change the wireless settings via a wireless device, you will be disconnected after the settings are applied.
Please write down the new SSID for future use.
¾ To hide the SSID of the extended network:
1. Go to
Settings
>
Wireless
2. Select
Hide SSID
broadcast, and the corresponding SSID will not be displayed when
wireless devices scan for local wireless networks. Devices must join the network
manually in order to connect.
3. 3.
Change LAN Settings
The extender is preset with a default LAN IP 192.168.0.254, with which you can log in to
the web management page. The LAN IP address, together with the Subnet Mask, also
defines the subnet that the connected devices are on. If the IP address conflicts with
another device on your local network or your network requires a specific IP subnet, you
can change it.
1. Visit http://tplinkrepeater.net, and log in with the username and password you set for
the extender.
2. Go to
Settings
> Network.
3. Select
Use the following IP
4. Enter a new IP Address as needed and leave the
and enter the gateway that is in the same subnet as the IP address. The gateway is
usually the LAN IP address of your extender.
>
Extended
Network.
Enable
>
Extended
Network.
Extended 2.4GHz SSID
>
Extended
Network.
address.
Customize Your Network
checkbox. In this case, all the wireless
or click
Copy Host
SSID. The value is case-
Subnet Mask
as the default settings
15
Advertisement
Table of Contents
