FujiFilm Finepix S1 Pro Software Manual page 12

AWB
Performs "one-push AWB" (automatic white balance setting). This option can be
specified when the white balance mode is set to "Custom".
TIP Set the white balance mode to "Custom" and click the [Apply] button to
enable the [AWB] button.
To perform "one-push AWB":
1 Hold up a piece of white paper in front of the viewfinder so that completely
covers the area photographed.
2 Click the [AWB] button. The shutter operates exactly as if the camera was taking
a picture and a white image is stored in the camera memory. The camera then
automatically sets the white balance based on the captured image.
3 Because the automatically set image is displayed in the scroll preview in the
Shooting window, you can visually check the results of "one-push
AWB".Subsequently, when you select "Custom", the camera uses the
automatically set white balance to take the picture. To change the "Custom"
white balance, click the [AWB] button again.
CAUTION • If you click the [Save] button to save photography settings file, do not
use "Initial 60", "System 60" or "Camera 60" as the file name since these
names are used by the Camera Shooting Software.
• if the "Cannot take the picture - the Camera is out of focus" message
appears, tick the "Focus lock" checkbox or set the camera focusing
mode to "M(Manual)" and then perform "one-push AWB".
TIP • You can enter a short comment for each set of photography settings.
This comment is saved in the photography settings file when you click
the [Save as...] button.
• If you open the "Shoot Conditions" dialog box after launching the
Camera Shooting Software, the current camera settings are imported
and displayed.
Camera Shooting Software
12