Gigabyte S461-3T0 User Manual page 71

Port Level Configuration
Partition Mode
Device Name
Chip Type
PCI Device ID
PCI Address
Link Status
Link Speed
Permanent MAC Address
Virtual MAC Address
Press [Enter] to configure advanced items.
Link Speed
Š
– Allows for automatic link speed adjustment.
– Options available: Auto Negotiated/1 Gbps/10 Gbps/SmartAN.
Default setting is Auto Negotiated.
Boot Mode
Š
– Select the preferred boot protocol or disable.
– Options available: PXE/Disabled. Default setting is PXE.
DCBX Protocol
Š
– Enables/Disables DCB Protocol.
– Options available: Disabled/IEEE/CEE/Dynamic. Default setting is
Dynamic.
RoCE Priority
Š
– Enter desired RoCE Priority within a range of 0 to 7
PXE VLAN Mode
Š
– Configure virtual LAN mode.
– Options available: Enabled/Disabled. Default setting is: Disabled.
Link Up Delay
Š
– Maximum amount of time in seconds UEFI or Legacy driver will
wait for Management FW to bring-up the link.
RDMA Protocol Support
Š
– Specifiy which Remote Direct Memory Access Protocol is to be
used.
– Options available: None/RoCE/IWARP. Default setting is: RoCE
Select the desired port partitioning mode.
Options available: Default/NPAR. Default setting is: Default
Displays the technical specifications for the Network Interface Controller.
Displays the technical specifications for the Network Interface Controller.
Displays the technical specifications for the Network Interface Controller.
Displays the technical specifications for the Network Interface Controller.
Displays the technical specifications for the Network Interface Controller.
Displays the technical specifications for the Network Interface Controller.
Displays the technical specifications for the Network Interface Controller.
Displays the technical specifications for the Network Interface Controller.
- 71 - BIOS Setup