Table of Contents
Advertisement
INSTALLATION OF LASER/RADAR ANTENNA
Antenna Cable to the Interface Box (iBox)
Once the antenna is installed, connect the antenna cable to the
quick disconnect interface cable. The antenna cable and the
interface cable have an arrow embossed in each plug. These
arrows must line up to properly to connect the cables together.
Run the cable along the edge of the engine compartment to
the firewall. Find a location in the firewall where other wires
(or the speedometer cable) enter the passenger compartment
and feed the phone jack connection through. Be careful not
to interfere with or disconnect other wires, cables, or
mechanical systems of your vehicle while routing the antenna
cable. If there is no easy way to route the cable through the
firewall, you can drill a 15/32" hole.
IMPORTANT: Check with the vehicle's manufacturer to see if
there are any issues with drilling through the firewall.
CAUTION: When drilling or working around the vehicle's
firewall, check the other side for any obstructions that might be
damaged.
The interface cable includes a rubber grommet to keep the
weather out of the vehicle. Also, keep the antenna cable away
from any areas in the engine compartment that may become hot.
Cable ties are provided to secure cables at various points in the
engine compartment and under the dash.
13
Advertisement
Table of Contents
