Panasonic ER‑PA10 Operating Instructions Manual page 2

Important
 Beforeuse 
This clipper is designed for professional use to trim hair and
beards. Charge it for 24 hours before use for the first time in order
to activate the built‑in rechargeable battery. Read all instructions
carefully before use.
 Chargingtheclipper 
• Use the ER‑PA10 hair clipper with the RE9‑59 charging stand
only.
• Avoid charging the battery at temperatures below 0 °C or above
40 °C.
• Avoid charging the battery in direct sunlight or near a radiating
heat source.
• Even though the clipper may not be used for an extended period,
charge every 6 months to preserve battery life.
• If the supply cord is damaged, it must be replaced by the
manufacturer, its service agent or similarly qualified persons in
order to avoid a hazard.
 Usingtheclipper 
• Warning ‑ Keep the appliance dry.
• The clipper may become warm during operation and/or charging.
This is normal.
• Check that the blades and the attachments are not damaged
before use. Replace them if they are damaged.
• You should not allow permanent wave lotion, hair restorer or hair
spray to come into contact with the main body or the blades.
Doing so may result in cracking, discoloring or corrosion.
• You should not drop the clipper on the floor.
• You should not knock the blades and the attachments against
hard objects.
• You should not trim the hair of a pet.
2
ER-PA10_ASIA.indb 2
 Cleaningtheclipper 
• Clean the housing using only a cloth slightly dampened with
water or a mild soap solution.
• Never use a caustic solution.
• Never submerge the clipper in water.
 Storingtheclipper 
• This appliance is not intended for use by persons (including
children) with reduced physical, sensory or mental capabilities, or
lack of experience and knowledge, unless they have been given
supervision or instruction concerning use of the appliance by a
person responsible for their safety. Children should be supervised
to ensure that they do not play with the appliance.
• Never tamper with moving parts.
• Avoid grabbing the clipper by the power cord, as it may become
detached, causing damage or injury.
• If the clipper is not working properly, have it inspected at an
authorized service center.
Specifications
Power source: See the name plate on the AC adaptor.
Motor voltage: 1.2 V
Charging time: 8 hours
READALLINSTRUCTIONSBEFOREUSE.
2013/06/13 20:53:09