List of ESC/VP21 Commands
USB Connection Setup
In order to control the projector using ESC/VP21 commands via a USB
connection, the following preparations must be carried out.
PROCEDURE
A
Download the USB driver (USB-COM Driver) from the
EPSON website to your computer.
Go to
http://www.epson.com
your local EPSON website.
B
Install the downloaded USB driver onto your
computer.
Read the instructions displayed on the download screen.
C
Change the "Link21L" setting in the "Extended" menu
to "On". If this is not set to "On", it is not possible to
communicate using a USB connection.
D
Turn the projector's power off.
E
Turn off this projector after the confirmation buzzer
beeps twice.
Once the projector's power has turned back on, communication
via a USB Connection will then be possible.
If you disconnect the power cable before the
confirmation buzzer beeps twice, the communication
port is not changed.
and select the Support section of
69