Table of Contents
Advertisement
2. Place the battery compartment cover over the battery, making sure that
the battery wires are carefully pushed down and the cover fits properly.
3. Gently tighten the screw in a clockwise direction using a small cross head
or flat end screwdriver.
2.3
Parent Unit Power Supply
IMPORTANT
Installing the rechargeable battery pack and charging it fully before use is
recommended. This will allow the unit to operate on battery in the event of a
power failure.
1. Connect the small plug of the power adapter to the Parent Unit and the
other end to the electrical outlet. Only use the supplied power adapter (5V
DC / 600mA) with the micro-USB style plug.
2. Press and hold the
the Parent Unit.
3. Once the Baby and Parent Units are switched on, the display on the Parent
Unit will show the video captured by the Baby Unit.
4. If there is no connection or you are out of range, the video display will go
off and the unit will beep every 5 seconds. Move the Parent Unit closer to
the Baby Unit until the link is re-established.
10
Micro USB Socket
Micro USB Plug
P
POWER ON/OFF button for 1 second to turn ON
Getting Started
Advertisement
Table of Contents
