Table of Contents
Advertisement
Color profile: Generic CMYK printer profile
Composite
Default screen
Clean the battery charging contacts on the base unit
with a dry cloth.
Check the connections between the base unit and the
mains power socket.
You need to replace the batteries.
"I try to
recharge the
Dispose of used batteries safely — never burn them,
batteries, but I
or put them where they could get punctured.
still get a
warning that
ALWAYS use the batteries supplied with your iDECT X1i
they are low."
— other batteries may burst, causing damage.
Use only with SANIK SN-2/3AAA40H J NiMH 400Ah
1.2V rechargeable battery.
PBX use
"The Flash
You may need to change the lash signal length from
its default of 600 ms. Consult your PBX documentation
function doesn't
for help if necessary. To change the recall setting, use
seem to work."
BASE SETTING
the
"Last Number
When you first make a call, after keying in the outside
line access code (e.g. 9), press and hold the Last
Redial and/or
Number Redial button until a
memory dialling
display. This inserts a pause between the access code
don't work on
and the telephone number. You should later be able to
a PBX."
redial the number.
When storing numbers in memory, you can include the
outside line access code (e.g. 9) with each number.
If your PBX requires you to wait for a second Dial tone
before dialling the telephone number, press and hold
the Last Number Redial button for a pause
between the access code and the number.
66
E:\Binatone2006\iDECT_X1i\iDECT_X1i_UK_03.vp
12 June 2006 10:54:07
Troubleshooting
F
menu (page 5 ).
3
P
appears on the
Advertisement
Table of Contents
