Installation; Electric Shock Can Kill; Select Suitable Location - Lincoln Electric LN-25X Operator's Manual

LN-25X™
Read entire Installation Section before installing the
LN-25X™ .

INSTALLATION

WARNING

ELECTRIC SHOCK CAN KILL.

• Turn the input power OFF at the
disconnect switch or fuse box before
attempting to connect or disconnect
input power lines, output cables or
control cables.
• Only qualified personnel should perform this
installation.
• Do not touch metal portions of the LN-25X™ work clip
when the welding power source is on.
• Do not attach the work clip to the wire feeder.
• Connect the work clip directly to the work, as close as
possible to the welding arc.
• Turn power off at the welding power source before
disconnecting the work clip from the work.
• Only use on power sources with open circuit voltages
less than 110 VDC.

SELECT SUITABLE LOCATION

For best wire feeding performance, place the LN-25X™ on a
stable and dry surface. Keep the wire feeder in a vertical
position. Do not operate the wire feeder on an angled surface of
more than 15 degrees.
Do not submerge the LN-25X™.
The LN-25X™ is rated IP23 and is suitable for outdoor use.
The handle of the LN-25X™ is intended for moving the wire
feeder about the work place only.
When suspending a wire feeder, insulate the hanging device from
the wire feeder enclosure.
CAUTION
High Frequency Interference Protection
Locate the LN-25X™ away from radio controlled machinery.
The normal operation of the LN-25X™ may adversely affect
the operation of RF controlled equipment, which may result
in bodily injury or damage to the equipment.
A-2
INSTALLATION