Where Will I Find - Mercedes-Benz C-Clas 2016 Owner's Manual

Vehicle tool kit
General notes
The towing eye is located in the stowage space
under the boot floor.
On vehicles with MOExtended tyres (tyres with
run-flat characteristics), the towing eye is in a
bracket under the parcel shelf.
Apart from some country-specific variants, vehi-
cles are not equipped with tyre-changing tools.
If the vehicle is equipped with a tyre-change tool
kit, it is located in a bag in the boot.
Some tools for changing a tyre are specific to
the vehicle. For more information on which tyre-
changing tools are required and approved for
performing a tyre change on your vehicle, con-
sult a qualified specialist workshop.
Necessary tyre-changing tools may include, for
example:
Jack
R
Wheel chock
R
Wheel wrench
R
Ratchet ring spanner
R
Centring pin
R
i
The jack weighs approximately 2.1 kg.
The maximum load-bearing capacity of the
jack can be found on the adhesive label on the
jack.
The jack is maintenance-free. In case of a
malfunction, please contact a qualified spe-
cialist workshop.
Vehicles with a TIREFIT kit
Tyre inflation compressor
:
Tyre sealant filler bottle
;

Where will I find...?

Open the boot lid.
X
Swing the boot floor upwards (
X
Use the TIREFIT kit (
X
i
Depending on the power category (LK), the
tyre inflation compressor weighs as follows:
LK1 – 12 V/10 A, 120 W: 0.8 kg
R
LK2 – 12 V/15 A, 180 W: 0.9 kg
R
You can find information on the power cate-
gory and/or electrical details on the back of
the tyre inflation compressor.
The tyre inflation compressor is maintenance-
free. In case of a malfunction, please contact
a qualified specialist workshop.
Vehicles with a tyre-change tool kit
The tyre-change tool kit is stored in a bag : in
the boot.
On vehicles with aluminium hub caps, the tyre-
change tool kit also contains a socket. Depend-
ing on the vehicle equipment, this is located in
the left stowage net or in the tyre-change tool kit
bag.
Towing eye
page 300).
Y
page 327).
Y
325