Table of Contents
Advertisement
Care
320
Cleaning the reversing camera and
360° camera
!
Do not clean the camera lens and the area
around the reversing camera or 360° camera
with a high-pressure cleaner.
Make sure that the vehicle is stationary.
X
Turn the key to position 1 or 2 in the ignition
X
lock (
page 133).
Y
or
Press the Start/Stop button once or twice on
X
vehicles with KEYLESS-GO or the KEYLESS-
GO start function (
Open the camera cover for cleaning via the
X
multimedia system; see Digital Owner's Man-
ual.
To clean the camera: use clean water and a
X
soft cloth to clean the camera lens :.
When you switch off the ignition, the camera
cover closes automatically.
Cleaning the exhaust tail pipes
G
WARNING
The exhaust tail pipe and tail pipe trim can
become very hot. If you come into contact
with these parts of the vehicle, you could burn
yourself. There is a risk of injury.
Always be particularly careful around the
exhaust tail pipe and the tail pipe trim. Allow
these components to cool down before touch-
ing them.
!
Do not clean the exhaust pipe with acid-
based cleaning agents, such as sanitary
cleanser or wheel cleaner.
!
Mercedes‑AMG C 63 and Mercedes‑AMG C
63 S with black exhaust pipes: Black chrome
page 133).
Y
trims must not be polished with a chrome
polish as this will cause them to lose their
black shine. To ensure optimum care, the
trims should be rubbed down with a lightly
oiled cloth after each time the car is washed.
Commercially available engine and mainte-
nance oils are suitable for use as oil.
In the event of heavier soiling, you may apply
a fine lacquer polish with a microfibre cloth.
Remove any excess polish paste after polish-
ing.
Impurities combined with the effects of road grit
and corrosive environmental factors may cause
flash rust to form on the surface. You can
restore the original shine of the exhaust pipe by
cleaning it regularly, especially in winter and
after washing the vehicle.
Clean the exhaust pipe with a care product
X
tested and approved by Mercedes-Benz.
Cleaning the trailer tow hitch
H
Environmental note
Dispose of oily and greasy cloths in an envi-
ronmentally-responsible manner.
!
Do not clean the ball coupling with a high-
pressure cleaner. Do not use solvents.
The ball coupling must be cleaned if it becomes
dirty or corroded.
Remove rust on the ball, e.g. with a wire
X
brush.
Remove dirt with a clean, lint-free cloth or a
X
brush.
After cleaning, lightly oil or grease the ball
X
coupling.
Check that the vehicle's trailer tow hitch is
X
working properly.
You can also have the maintenance work on the
ball coupling and the trailer tow hitch carried out
by a qualified specialist workshop.
Advertisement
Table of Contents
