Nokia RM-407 User Manual page 63

Access point name — Enter the name for the
access point. The name is usually provided by
your service provider.
User name — Enter your user name if required
by the service provider. User names are often
case-sensitive and provided by your service
provider.
Prompt password — Select Yes to enter your
password each time you log into a server or
to save the password in your device memory and
automate the login.
Password — Enter your password if required by
the service provider. The password is often case-
sensitive and provided by the service provider.
Authentication — Select Secure to send your
password always encrypted, or Normal
your password encrypted when possible.
Homepage — Enter the web address of the page
you want to display as the home page when you
use this access point.
4. After defining the settings, select Options
Advanced settings to define the advanced
settings or Back to save the settings and exit.
Advanced internet access
point settings for packet
data (GPRS)
Select Menu Tools Settings Connection
Access points.
Cyan Cyan Cyan Cyan Magenta Magenta Magenta Magenta
After setting up a basic internet access point for packet
data (GPRS), select Options Advanced
and define the following advanced settings:
Network type — Select IPv4
protocol type. The internet protocol defines how
data is transferred to and from your device.
Phone IP address — Enter the IP address of your
device. Select Automatic to have the network
No
provide the device IP address. This setting is shown
only if you select Network type
DNS address — Select Primary DNS address
Secondary DNS address and enter their IP
addresses, if required by your service provider.
Otherwise, the name server addresses are provided
automatically.
to send
Proxy server address — Enter the address of the
proxy server. Proxy servers are intermediate servers
used by some service providers between a browsing
service and its users. These servers may provide
additional security and speed up access to the
service.
Set up an access point for
WLAN manually
1. Select Menu Tools Settings
Connection Access points.
2. Select Options New access point
new access point, or select an existing access point
from the list and then Options
point to use the access point as a basis for the new
one.
3. Define the following settings.
Yellow Yellow Yellow Yellow Black Black Black Black
settings,
or IPv6 as the internet
IPv4.
and
to create a
Duplicate access
63