Accessory Maintenance - DeWalt D25961K Manual

1. Loosen the clamp knob (c) and rotate the side
handle to the desired position.
3. Lock the side handle in place by tightening the
clamp knob (c).
OPERATION
Instructions for Use
WARNING:
• Always observe the safety instructions
and applicable regulations.
• Be aware of the location of pipework and
wiring.
• Apply a pressure of approx. 20 - 30 kg
to the tool. Excessive force does not
speed up chiselling but decreases tool
performance and may shorten tool life.
Proper Hand Position (fig. 2)
WARNING: To reduce the risk of
serious personal injury, ALWAYS use
proper hand position as shown.
WARNING: To reduce the risk of
serious personal injury, ALWAYS hold
securely in anticipation of a sudden
reaction.
IMPORTANT: The tool must be held with two hands
at all times when in use.
Horizontal applications ( g. 2A):
Proper hand position requires one hand on the side
handle (f) and the other hand on the main handle (b).
Vertical applications ( g. 2B):
Proper hand position requires both hands on the
main handle (b).
Switching On and Off (fig. 1)
Switching on: set the on/off switch (a) to position 1.
Switching off: set the on/off switch (a) to position 0.
Demolition, Chasing and Channelling
(fig. 1, 2)
1. Select the appropriate chisel, and clean its
shank.
2. Insert the chisel and check whether it is properly
locked.
3. Fit and adjust the side handle (f) and make sure
it is firmly tightened.
4. Hold the tool with two hands on the main
handle (b) or one hand on the main handle (b)
and one hand on the side handle (f). The tool
must be held with two hands at all times when
in use. Refer to Proper Hand Postion.
5. Switch on tool to run in continuous operation.
6. Always switch off the tool when work is finished
and before unplugging.
Various types of chisels are available as an option.
Only D WALT recommended accessories should be
E
used with this product.
MAINTENANCE
Your D WALT power tool has been designed to
E
operate over a long period of time with a minimum
of maintenance. Continuous satisfactory operation
depends upon proper tool care and regular cleaning
This machine is not user-serviceable. Take the tool
to an authorised D WALT repair agent periodically.
E
If problems occur before this time contact an
authorised D WALT repair agent.
E

Accessory Maintenance

WARNING: These chisels can be
reground only a limited number of
times. If in doubt, contact your dealer for
recommendations.
WARNING: Ensure that the cutting
edge does not show discolouration
caused by too much pressure. This may
impair the hardness of the accessory.
For the best results only use sharp chisel bits.
Sharpening chisel bits frequently will guarantee
long life of the chisel bits and the best performance
results.
GRINDING
Refer to figure 5 for the types of chisels to use with
this tool.
Grind the chisels on grinding discs with continuos
water flow. Refer to figure 6 for the appropriate
angles of the following chisels:
k. pointed chisel
l. flat chisel
m. wide scaling chisel
n. clay spade
E N G LISH
(fig. 5,6)
9