Table of Contents
Advertisement
Replacing nozzles
1. Unscrew screw A and push air
regulator B as far as it will go.
2. Remove the nozzles C using a 7 mm
spanner and install the ones suitable for
the new type of gas, following the
indications given in the relevant tables
(see "Gas types and Countries").
The nozzle tightening torque must
be no more than 3 Nm.
3. Adjust the air flow by moving the air
regulator B to obtain the distance D
given in the corresponding table (see
"Gas types and Countries").
4. After having adjusted each burner,
reassemble the appliance following the
disassembly instructions in reverse (see:
"5.5 Adaptation to different types of gas
- Removing the hob").
Installation
After having set the distance of the air
regulator "D", the flame may appear as
illustrated:
• 1: the flame is "noisy" and "detaches"
from the burner: the air regulator has
been opened too far.
• 2: the flame is opaque, dull or has
yellow tips and "wraps around" the
burner: the air regulator has been closed
too far.
• 3: the flame is light blue, clear and
stable, does not "detach" or "wrap
around" the burner: the air regulator is
adjusted correctly.
59
Advertisement
Table of Contents
