Table of Contents
Advertisement
Cleaning and Maintenance
Be sure to disconnect the power plug from the socket before cleaning the product.
Cleaning the air purifier exterior
• Dampen a soft cloth with lukewarm water and wring it out, and then wipe the product exterior with it.
• Wipe the grooves on the front and rear panels with a cotton swab.
• If it is too hard to clean the dust from the front or rear panel, remove the panel and wash it with water.
Caution
• Do not wipe the product with an alkaline detergent.
• Do not wipe the product surface with sulphuric acid, hydrochloric acid, or organic solvents (thinner,
kerosene, acetone, etc.). Do not attach a sticker to the product. Failure to do so may result in
damage to the product surface.
Cleaning the sensors
Cleaning and drying the front panel
01
02
03
Dry and then reassemble
26
English
• If there is dust or foreign substance on a sensor,
use a vacuum cleaner to clean the sensor and its
surrounding.
Caution
• Do not put any dust into the sensor openings.
STEP 1 Remove the front panel.
• Hold and pull the front panel forward until it is removed.
– If you have difficulty in removing the front panel
because it is closed, turn on the power, unplug the
power cord while the front panel is open, and then
remove the front panel.
STEP 2 Clean and dry the front panel.
• Clean any dirt or foreign substance on the front panel
with water or a soft cloth.
• After cleaning with water, thoroughly dry the front panel
before reassembling it to the product.
STEP 3 Reassemble the front panel.
• Insert the hook at the bottom of the front panel into the
bottom fixing groove, and then press the top center of the
front panel so that it is assembled to the product.
– If the front panel is open, connect the power cord and
turn on the product so that the product operates and
the front panel returns to its closed position.
Advertisement
Table of Contents
