Safety Instructions; Connection Of The Signal Cables - Siemens SIPROCESS UV600 Manual

4.5.2.1

Safety instructions

NOTICE
Device failure
The internal electronics can be damaged if you make the signal connections with the device
switched on.
• Therefore disconnect the SIPROCESS UV600 from the power supply before you make
Note
Measured-value output during calibration
The measured calibration gas values are output during the calibration, and the status
"Function check" is activated.
• Check that the status message is displayed externally or has to be processed.
• Make sure that the corresponding digital output is installed.
4.5.2.2

Connection of the signal cables

The signal connections are available at terminal strips X3, X4, X5 and X7 on the 12-pin plug
connectors of the input/output modules (see following Fig.). Depending on the configuration,
the device has 1 or 2 input/output modules. The scope of delivery includes the
corresponding counterparts with screw terminals.
6
8
Figure 4-4
SIPROCESS UV600
Operating Instructions, 10/2013, A5E03529375-02
the signal connections.
Internal input/output module (standard) with terminal strips X3, X4, X5 and X7
Connection plug
Signal connections and plug connectors
Mounting and connecting
4.5 Electrical connections
33