Troubleshooting; The Procedure Of Setting Option - Samsung AC026JNNCEH Service Manual

4. Troubleshooting

▶ Set the indoor unit address and installation option with remote controller option.
Set the each option separately since you cannot set the ADDRESS setting and indoor unit installation setting option at the
same time.You need to set twice when setting indoor unit address and installation option.
▶ Please use the proper wireless remocon which can set 24 digit option code. Following is the instructions of setting option
code with wireless remocon of MR-EH00U.
▶ Please refer to the wired remocon installation manual for setting with the wired remocon.

4-4-1 The procedure of setting option

Entering mode for
High Temp Button
Step 1. Entering mode to set option
1. Remove batteries from the remote controller.
2. Insert batteries and enter the option setting mode while pressing High Temp button and Low Temp button
3. Check if you have entered the option setting status.
Step 2. The procedure of option setting
After entering the option setting status, select the option as listed below.
Option setting is available from SEG1 to SEG 24
• S EG1, SEG7, SEG13, SEG18 arenot need to be set at MR-DH00. They are the page options which were used at the
previous other remocons.
• Set the each 2 bit option code in order except page options.
For example : SEG2, 3  SEG4, 5  SEG6, 8  SEG9, 10  SEG11, 12  SEG 14, 15  SEG 16, 17  SEG 18, 20
 SEG 21, 22  SEG23, 24.
SEG1 SEG2 SEG3
0 X X
SEG13 SEG14 SEG15 SEG16 SEG17 SEG18 SEG19 SEG20 SEG21 SEG22 SEG23 SEG24
2 X X
Samsung Electronics
setting option
Low Temp Button
SEG4 SEG5 SEG6 SEG7 SEG8
X X X 1
X X X 3
SEG9 SEG10 SEG11 SEG12
X X X X X
X X X X X
Option
setting mode
Mode change
High Fan Button
Low Fan Button
On(SEG1~12) Off(SEG13~24)
.
4-1