Requirements - Xilinx Virtex-7 FPGA VC7215 Getting Started Manual

Requirements

The hardware and software required to run the GTH IBERT demonstrations are:
• VC7215 Virtex-7 FPGA GTH Transceiver Characterization Board. Includes:
Three SD cards labeled IBERT #1, IBERT #2, and IBERT#3 containing the IBERT
°
demonstration designs
One Samtec BullsEye cable
°
Eight SMA female-to-female (F-F) adapters
°
Six 50Ω SMA terminators
°
Two GTH transceiver power supply modules (installed on board)
°
SuperClock-2 module, Rev 1.0 (installed on board)
°
12V DC power adapter
°
USB cable, standard-A plug to Micro-B plug
°
• Host PC with:
SD card reader
°
USB ports
°
• Vivado Design Suite 2015.1
The hardware and software required to rebuild the IBERT demonstration designs are:
• Vivado Design Suite 2015.1
• PC with a version of the Windows operating system supported by Vivado Design Suite
VC7215 Getting Started Guide
UG970 (Vivado Design Suite v2015.1) April 27, 2015
Chapter 1: VC7215 IBERT Getting Started Guide
www.xilinx.com 5
Send Feedback