Fan Relay - Frigidaire PLEF489CCG Service Data Sheet

MOUNTING PLATE OVEN
The fan motor on the rear of the unit is mounted to the main back with three screws. There is a mounting plate
held in place between the main back (with 2 screws) and the rear oven wall (with 2 screws). Should it be
necessary to replace the oven cavity, you must remove the 2 screws located inside the unit at the rear of the oven
cavity.

FAN RELAY

The fan motor runs continuously while in the convection mode unless the door is opened. If the fan does not operate,
check the following:
• Display illuminated on the electronic control.
• Voltage output between terminals E9 and E8.
• 240 Volts available at fan motor.
• Fan motor coil resistance 56.5 ohms ± 10%.
• Voltage input to fan relay coil during convection bake with door closed.
• Door/light switch.
EXPLODED VIEW OF CONVECTION SYSTEM (typical)
Convection Fan
Motor Assembly
ERC III ELECTRONIC OVEN CONTROL FAULT CODES (conti
Oven Cavity
Convection Fan
Blade
Fan Nut
6
Convection Element
Convection
Fan Cover