Paradox SP6000 Programming Manual page 63

Magellan & Spectra SP • Programming Guide
SP4000
1 Paradox Memory Key (PMC5)
2 EBUS (J3) and Dialer (J4) used with:
• VDMP3 Plug-in Voice Module for voice reporting
• PCS Series Communicator Module
3 Status LED:
• Flash once every second: Normal
• Flashes ON 1 sec. and OFF 1 sec.: Any trouble
• Always ON: Panel is using phone line
• Fast flash 6 seconds after power-up: Installer lock enabled
4 Serial: Used for connecting the IP Internet Module/PCS (Data); also used
for In-Field Firmware upgrade through a 307USB Direct Connect Interface
5 Refer to Single Zone Inputs on page 13
6 PGM Output: Refer to Alarm Relay and PGM Connections on page 60
7 16.5 Vac (50 or 60 Hz), minimum 20 VA (40 VA recommended)
This equipment must be installed and maintained by qualified service personnel only.
For UL and C-UL warnings, refer to the UL and C-UL Warnings section at the back of the MGSP Reference & Installation Manual.
Max. number of keypads: 15 keypads
Max. aux. current: 700 mA
Max. distance of bus module from panel: 76 m (250 ft.)
Max. total run of wire: 230 m (750 ft.)
To provide maximum
lightning protection we
strongly recommend having
separate earth connections
for the dialer and zone
ground terminals.
8 Refer to AC Power & Backup Battery Connections on page 3
9 The output will shutdown if the current exceeds 3A
BELL
10 AWG #14 single conductor solid copper wire
11 Cold water pipe grounding
12 Ground clamp
13 To metallic enclosure
14 For the keypad's zone configurations
15 If EOL is enabled, see section [706] option 2,
on page page 34. Also refer to Keypad Zone Connections on page 13.
16 To connect additional wiring to auxiliary power, use the red (+) and black
(-) keypad connectors; auxiliary power will shut down if current exceeds
1.1A; if the auxiliary output is overloaded and shuts down, you must
disconnect all loads from the output for at least 10 sec. before
reconnecting any load back to the auxiliary output
Disconnect telephone line
before servicing.
63