AT&T CL81211 User Manual page 11

Getting started
Battery installation and charging
Step 1
Plug the battery
connector securely
into the socket inside
the handset battery
compartment. Insert the
supplied battery with
the label THIS SIDE UP
facing up, as indicated.
CHARGE light
After you install your telephone or power returns following a power
outage, the handset will prompt you to set the date and time. For
instructions, see Set date/time in the telephone system's user's
manual for details. To skip setting the date and time, press
CANCEL.
OFF/
IMPORTANT INFORMATION
1. Use only the supplied rechargeable battery or replacement battery
(model BT183342/BT283342).
www.telephones.att.com
In Canada, dial
2. If you do not use the handset for a long time, disconnect and remove
the battery to prevent possible leakage.
Step 3
Charge the handset by placing it face forward in the
telephone base or charger. The CHARGE light on the
top of the handset is on during charging.
1 (866) 288-4268
To order, visit our website at
1 (800) 222-3111
or call
.
7
Step 2
Align the cover
flat against
the battery
compartment,
then slide it
upwards until it
clicks into place.
.