Canon OPTURA200 MC Instruction Manual page 93

Dubbing
1. Find a point on your recorded cassette slightly before the
section you wish to copy and set it to playback pause mode.
2. Press the REC PAUSE button on the wireless controller.
• The camcorder enters record pause mode.
3. Start playback on the other digital device while you monitor
the picture.
4. Press the pause button.
• Recording starts.
5. When you get to the point where you wish to stop
recording, press the stop button or the pause button.
• Recording stops.
6. Stop playback on the other device.
Notes:
• Blanks between recordings on the playback tape are recorded as
anomalous images on the tape that is being recorded to.
• When dubbing to a tape via the DV terminal, make sure that AV \ DV is
not displayed on the screen. If so, set AV \ DV OUT to OFF (
Copyright Signal
Certain pre-recorded software tapes are copyright protected. If you try to
play back such a cassette, "COPYRIGHT PROTECTED PLAYBACK IS
RESTRICTED" appears in the display for a few seconds and then the
camcorder displays a blank blue screen; you cannot view the contents of the
cassette.
If you try to record from such a tape via the digital cable "COPYRIGHT
PROTECTED DUBBING RESTRICTED" appears in the display; you cannot
record the contents of the tape.
E
97).
93