Table of Contents
Advertisement
Uninstalling the MXD-700
The MXD-700 is held in place to the back box via latch hooks and clips on the back box (FIG. 21), securing it
to the mounting surface. In certain circumstances, such as firmware updates or other maintenance that requires
accessing the device's USB port, the device may need to be removed from the back box. The clips that lock
down the MXD-700's bottom edge (Landscape) or right edge (Portrait) may be unlatched in order to remove
the device from the mounting surface.
To remove an MXD-700 from its back box:
1.
The bottom (Landscape) or right side (Portrait) of the MXD-700 has a series of ventilation holes along
the molding (FIG. 21). From each end, count to the fifth holes on the center row.
FIG. 21
Underside of MXD-700
2.
With a stout, strong point (a push pin or straightened paper-clip, for example), carefully press into the
access holes in either end of the molding (FIG. 22) until the snap is disconnected. To facilitate the
disconnection, grasp the bottom of the panel (Landscape) or right side (Portrait) and pull gently outward
until the side of the panel is free of the snap. Use your other hand to hold stable the front of the touch
panel.
FIG. 22
Location of access holes on MXD-700 molding
Always pull on the frame of the touch panel. NEVER pull on the glass edge.
3.
When the first side is free, repeat the process with the other.
4.
With the edge of the touch panel free, carefully lift up and out (Landscape) or to the left and out (Portrait)
to remove the touch panel from the back box. Be careful not to pull on the cables or connectors.
5.
To reattach the panel to its back box, repeat the installation procedure on page 20.
For further information on this procedure, please refer to the video available at the
AMXconfigure channel on YouTube: http://www.youtube.com/user/AMXconfigure
MXD/T-700 7" Modero X Series® Touch Panels
Molding
Access holes
Installation
21
Advertisement
Table of Contents
