Table of Contents
Advertisement
Installation
Installation Recommendations
During any installation, a lack of ventilation may produce conditions that may adversely affect the device's
operation. In these circumstances, special care must be made to make sure that temperatures within enclosed
areas do not exceed the device's maximum rated temperature.
While the outside temperature of the device may be at or below its maximum
operating temperature, special care must be taken before and during installation to
ensure that the maximum operating temperature is not exceeded within wall or rack
installation spaces.
MXD-700 Installation
The MXD-700 may be installed directly into a solid surface environment, using either solid surface screws or
the included locking tabs for different mounting options. Once installed, the MXD-700 is contained within a
clear outer housing known as the back box (FIG. 14). This back box is removed when installing the device into
a wall or into a Rough-In Box.
FIG. 14
MXD-700 Back Box
Power Via Power Over Ethernet
Power for the MXD-700 is supplied via Power Over Ethernet (PoE), utilizing an AMX-certified, capacitive
touch-compliant PoE injector or other approved AMX PoE power source. The incoming Ethernet cable should
be connected to the RJ45 port on the MXD-700 (FIG. 15 and FIG. 16).
RJ45
Cable
Clip
RJ45
Port
FIG. 15
Rear of the MXD-700 (Landscape)
16
Locking tab
Locking tab
USB
Port
MXD/T-700 7" Modero X Series® Touch Panels
Top
Advertisement
Table of Contents
