Download Print this page

Troubleshooting - MASSEY FERGUSON 2800 Series Operator's Manual

Hide thumbs Also See for 2800 Series:

Advertisement

Available languages

Available languages

Troubleshooting

Troubleshooting the Tractor
PROBLEM
Engine will not turnover
or start.
Engine starts hard or
runs poorly.
Engine knocks.
Excessive oil
consumption.
Engine exhaust is black.
Engine runs, but tractor
will not drive.
30
LOOK FOR
Brake pedal not
depressed.
PTO (electric clutch)
switch is in ON position.
Cruise control engaged.
Out of fuel.
Engine fl ooded.
Fuse is blown.
Battery terminals require
cleaning.
Battery discharged or
dead.
Wiring loose or broken.
Solenoid or starter motor
faulty.
Safety interlock switch
faulty.
Water in fuel.
Gas is old or stale.
Fuel mixture too rich.
Engine has other problem. See authorized dealer.
Low oil level.
Using wrong grade oil.
Engine running too hot.
Using wrong grade oil.
Too much oil in
crankcase.
Dirty air fi lter.
Choke closed.
Ground speed control
pedals not depressed.
Transmission release lever
in PUSH position.
Parking brake is engaged.
Traction drive belt is
broken or slipping.
Fully depress brake pedal.
Place in OFF position.
Move knob to NEUTRAL/OFF position.
If engine is hot, allow it to cool, then refi ll the fuel tank.
Disengage the choke.
See authorized dealer.
See Cleaning the Battery and Cables section.
Recharge or replace battery.
Visually check wiring. If wires are frayed or broken, see
authorized dealer.
See authorized dealer.
See authorized dealer.
See authorized dealer.
See authorized dealer.
Clean air fi lter.
Check/add oil as required.
See Oil Recommendations Chart.
See authorized dealer.
See Oil Recommendations Chart.
Drain excess oil.
See Servicing the Air Filter section.
Open choke.
Depress pedals.
Move into DRIVE position.
Disengage parking brake.
See authorized dealer.
REMEDY

Advertisement

loading

This manual is also suitable for:

2830