Download Print this page

MASSEY FERGUSON 2800 Series Operator's Manual page 13

Hide thumbs Also See for 2800 Series:

Advertisement

Available languages

Available languages

Set the Clock - Start the engine, leave the engine running.
Depress the select button (C) for three (3) seconds and
release. Depress set button and HOLD to advance time.
Depress select button to select minutes. Depress and HOLD
set button (D) to advance time. Leave alone for 5 seconds
and clock will activate. Shut off engine.
Demonstration Mode - With the engine off, hold down the
set button (D) and turn the key switch to RUN.
Maintenance Reminder - A maintenance reminder will
display in the information window (B) after the first 5 hours
of operation, and then after every 50 hours. The reminder
will automatically reset after 5 hours. The reminder can be
manually reset by turning the key switch from OFF to RUN
(with engine off) and then depressing the set (D) and select
(C) buttons simultaneously for 5 seconds.
Parking Brake Function
Applying the Parking Brake - See Figure 4. To lock the
parking brake, release the ground speed pedals (A), fully
depress the brake pedal (B), pull UP on the parking brake
knob (C), and then release brake pedal.
Releasing the Parking Brake - See Figure 4. To release
the parking brake, fully depress the brake pedal (B) and
push the parking brake knob (C) DOWN.
NOTICE: The hydraulic attachment lift and power steering
will not operate when the brake pedal is depressed.
Releasing the brake pedal restore operation.
C
en
Automatic Controlled Traction
What is Automatic Controlled Traction?
Automatic Controlled Traction (ACT) is an exclusive feature
of our transmissions that provides improved traction. ACT
applies a preset amount of torque to both rear wheels even if
one starts slipping (a transmission without ACT will lose trac-
tion completely if one rear wheel starts slipping). This preset
torque is just enough to provide additional traction, and still
allow the wheels to turn at different speeds in a tight turn
without damaging the lawn.
What to Expect from Your ACT Tractor
For the most part, while using your tractor you will not notice
ACT working, and you will simply become accustomed to
increased traction an ACT transmission provides.
Under certain circumstances the ACT system limit can be
exceeded, and one of the rear wheels may slip (for instance
if trying to turn up a hill while accelerating). This is normal. If
you start to lose traction, do not speed up. Instead, slow to
a stop, straighten the steering wheel, and slowly accelerate.
Stopping the tractor allows the transmission to regain more
traction.
12 Volt Power Outlet
The 12-volt accessory plug is located in the left side pod. It
can be used to power small electronic devices. The accessory
must be rated at 9 amps or less.
NOTE: Operating a 12-volt accessory, especially with the
engine at idle, may cause battery discharge. When not using
the accessory plug it must be covered with the rubber plug
to prevent moisture from causing a short circuit. Entrance of
water into plug can cause a short circuit.
B
A
Figure 4
13

Advertisement

loading

This manual is also suitable for:

2830