Table of Contents
Advertisement
UB334 Paper OM reduced size.fm Page 30 Friday, September 9, 2005 11:16 AM
direction upward.
current search direction.
Storing Frequencies Found During
Chain Search into Channel Memory
You can store frequencies you find in chain search
mode or chain search hold mode.
1. Press Func + Pgm in chain search mode or
chain search hold mode. The lowest blank
channel appears.
2. Press E/Pgm to store the frequency into the
blank channel. To select another channel, press
Func +
or Func +
E/Pgm.
If you try to save a frequency that is already stored,
the scanner sounds an error tone and displays the
channel that was duplicated. If you entered the
frequency by mistake, press /Clr. To enter the
frequency anyway, press E to accept.
The scanner sets itself to program mode after you
store a frequency.
Setting the Search Range
You can use this mode to define the search range
used during a search in each search bank. To
change a search range, press Func and PSrc.
SRCH appears. Then select a search bank.
When you select the search bank, the lower limit
and upper limit frequency assigned in the search
bank alternate on the display.
To select another search bank, press Func + PSrc
or Func +
to increase the search bank number
or Func +
to decrease it. Hold down Func +
or
appears according to the
before you press
Special Features
30
or
Hide quick links:
Advertisement
Table of Contents
