Table of Contents
Advertisement
To apply the thermal grease compound:
Use a clean cloth dipped in rubbing alcohol to clean the contact surface on the heat sink and the
1.
new processor. Wipe the contact surfaces several times to make sure that no particles or dust
contaminants are evident.
Apply the thermal grease compound to the CPU contact surface.
2.
CAUTION: HP recommends using Shin-Etsu X-23-7783D thermal grease compound for your ProLiant
server.
Apply all the grease to the top of the processor in one of the following patterns to insure even
3.
distribution.
Figure 37 The Top of the Processor
CAUTION: Never touch the bottom of the processor; any contaminant could prevent the mounting
pads from making contact with the socket.
CAUTION: Applying too much grease creates a gap between the contact surfaces, significantly
reducing the ability of the heat sink to draw out heat. Installing the heat sink with excessive grease
can also cause the grease to spread over the processor pins or the system board base, which can
cause electrical shorts that damage the system.
Removal and replacement procedures 71
Advertisement
Table of Contents
